EZ-TILT-1000-008 Evaluation board
The EZ-TILT-1000-EVAL two degree of freedom inclinometer is built around a customized state of the art CMOS Microcontroller. The tiny SO18-SMD or DIP-18 customized IC is capable of providing continuous inclination information for dual axis tilt sensors in a standard RS-232 format with 8 bit resolution. An additional analog input on pin #17 is available for optional temperature or any other
environmental input used for monitoring or correction of the output. Evaluation
unit communicates through “TERMINAL “ mode in Windows, or by utilizing custom software DX-232-A, which is provided at NO cost with each order.
This low cost inclinometer includes DX-008 tilt sensor and is perfectly suitable for concept verification for OEM markets such as VIRTUAL REALITY, TOYS, AUTOMOTIVE, COMPUTER, and CONSUMER
ELECTRONICS. The EVALUATION MODULE is able to operate with any Dual axis Electrolytic tilt sensor. The EZ-TILT-1000
EVALUATION module could be supplied calibrated with raw data stored on a 3.5” disk in ASCII format and includes self test to confirm sensors presence on
POWER UP or RESET.
| Specification | Data | Description/units |
|---|---|---|
| RANGE | -20 to +20 | Arcdeg monotonous |
| SUPPLY | 5 | Vdc |
| RESOLUTION | 8 | bit |
| RESPONSE TIME | 20 mS | after request command |
| SENSING ELEMENT | Dual/Single axis | all sensors |
| CONSTRUCTION | 1.5" x 1.5" | sqr. PCB |
| TEMPERATURE | -40 to +85 | degC IC only |
| RS232 | 19200,8,N,1 | with 8Mhz crystal |
* Evaluation board shown above in the photo is sold to be used with any PC in DOS or Windows.
# Based on standard non-modified electrolyte.
# Viscosity of the electrolyte may be modified to filter out vibration.
Specifications may change without notice.
 |
ADVANCED ORIENTATION SYSTEMS, Inc. 2525 BRUNSWICK AVE, Suite 205 LINDEN, NJ 07036, USA. Phone: 908-474-9595 Fax: 908-474-9090 sales@aositilt.com http://www.aositilt.com |