EZ-TILT-3000-045 DUAL TILT AXIS WIDE ANGLE CONVERSION MODULES for electrolytic inclinometers and rugged polymer tilt sensors
EZ-TILT-3000-045-90 Dual Axis Extended Wide Angle Conversion Module
The standard two degree of freedom ANALOG tilt module is built around a customized state of the art CMOS SMT and Feed Through components. A 2" x 2" assembled PCB has a total height including the sensing element of 17mm max. Analog proportional-to-tilt DC voltage output provides continuous inclination information for both axis of tilt. This LOW cost module is perfectly suitable for numerous OEM wide angle inclination applications. The module includes independent NULL and GAIN adjustments for both Pitch and Roll. Temperature value is available as a separate output for external reference upon request. Module is capable of operating with any type of Single or Dual axis Electrolytic tilt sensor. Sensor could be remotely located if so required. Module could be supplied calibrated with raw data stored on a 3.5" disk in ASCII format. Electrolyte may be modified to filter out errors induced by shock & vibration.
* Elapsed time until the sensor reacts to a tilt disturbance.
|RANGE||-90 to +90||Arcdeg monotonous|
|SUPPLY||5 to 18||Vdc|
|CURRENT||2mA||@ 5Vdc Supply|
|RESPONSE TIME||40 mS||10% - 90% Output *#|
|NOISE||<1mVdc||Band Width 0Hz to 100Hz|
|LOAD (min. R )||3Kohm||On -X- and -Y- Outputs|
|SYMMETRY||<2% @ 35°||Typical|
|LINEARITY||<7% @ 70°||Typical|
|SENSING ELEMENT||Dual axis DX-045-90||(Included)|
|CONSTRUCTION||Shatter proof||Hi Temp Advanced Polymer|
|TEMPERATURE||-40 to +60||degC|
|SIZE||2.0" x 2.0" x 0.600"||( W x L x H )|
| ||-90 to +90 Arcdeg||range is available upon special request.
# Based on standard non-modified electrolyte.
# Viscosity of the electrolyte may be modified to filter out vibration.
Specifications may change without notice.